Dragonfly Spirit Leather Necklace

Dragonfly Spirit Necklace Tamara Scott Designs

Attach the dragonfly charm to the end of an eye pin with a jump ring, string the three beads, end with a wired wrapped loop. Fold the leather in half, insert the loop through the focal bead and run the other ends through the loop. String the next three beads as shown over the double strands of leather. Run both strands of leather up through the connector and down the second hole. Run each strand of leather up through the ends of the first hole of the six strand connector, cross in the center and run down the second hole of the connector. Establish the necklace length (approximately 12 inches or more, depending on the length you would like) tie a knot using both strands, leave a 2-inch space, add the bead set and end with another knot, trim the end. Enjoy : ) tamarascottdesigns.com

Wire Wrapped Loop & Basic Stringing Illustrations:

Dragonfly Spirit Blog Tutorial Tamara Scott Designs

Dragonfly Spirit Leather Necklace Tamara Scott Designs

Taupe Sea Necklace Components Tamara Scott Designs